| Technical Parameters |
| the exterior diameter range of the grinding ball valve |
¦µ160~¦µ320 |
| Maximum working weight |
150kg |
| Maximum abrasive diameter linear velocity |
35m/s |
| Abrasive rotation speed |
stepless speed adjusting |
| abrasive frame feed rate |
|
| hand wheel per ring (thick) |
2mm |
| hand wheel per ring (thin) |
0.5mm |
| hand grille per ring (thick) |
0.01mm |
| hand grille per ring (thin) |
0.0025mm |
| speed up and slow down (hydraulic pressure) |
50mm |
| fast moving time |
¡Ü3S |
| head rest |
|
| head rest flip angle |
90¡ã |
| Morse taper of the cone hole of the main shaft |
No. 4 |
| work piece rotation speed |
stepless speed adjusting |
| tail stock |
|
| maximum moving amount of the pin sleeve |
30mm |
| Morse taper of the cone hole of the pin sleeve |
No. 4 |
| working table |
|
| the moving amount of the working table for the big hand wheel per ring |
¡Ö6mm |
| the moving amount of the working table for the small hand wheel per ring |
0.12mm |
| the moving amount of the working table for the small hand wheel per ring |
0.005mm |
| cooling pump flow amount |
25L/min |
| hydraulic pump flow amount |
16L/min |
| machine tool motor power |
|
| grinding wheel motor |
7.5KW |
| head rest motor |
2.2KW |
| cooling pump motor |
0.12KW |
| hydraulic pump motor |
0.75KW |
| machine tool electrical power |
3M 380V 50HZ |
| machine tool exterior size |
3000¡Á1750¡Á1860 |
| machine tool net weight |
3800Kg |
| |
|
| grinding wheel main shaft transmission |
The grinding wheel main shaft motor is driven by belt pulley 1:2 and belt 8
. |
| grinding wheel frame feeding transmission |
Transmission hand wheel-¡úgear 16-¡úsliding gear 17-¡úgear 18-¡úgear 19-¡úscrew mandrel 20¡úhalf nut 21¡úmaking the grinding wheel feed, moving the sliding gear 17, which can make the grinding wheel rest have two feeding amounts. |
| head rest transmission |
The head rest motor undergoes the belt pulley 3:4 and belt 9¡úbelt pulley 4:5 and belt 10¡úbelt pulley 6:7 and belt 11, and the head rest is driven by the dish, to make the work piece rotate.?? ????
|
| work table retation |
Rotate the big hand wheel-¡úgear 34-¡úgear 23-¡úgear 26-¡úgear 25-¡úgear 22 to bring the work table fast movement
. |
Rotate the small hand wheel-¡úworm 35-¡úworm wheel 36-¡úgear 24-¡úgear 23-¡úgear 26-¡úgear 25-¡úgear 22, to bring the small work table a miniature movement. |
| tail stock move |
| The spring fastens the top, and when the top secede, with the foot stepping the hydraulic panel, the cylinder motion or the handle trigging will make the top secede. |
